Cooper Security 9853 Guida di Installazione Scaricare il pdf (Pagina 26)

20 496791

3. Installation

FSL

EOL

Four-wire CC

Two-wire FSL

Two-wire EOL

Figure 15. Jumper Positions to Select Connection Types

Once you have connected a 9954 expander refer to the instructions supplied

in order to connect detectors.

Once you have connected a 9955 expander then refer to the instructions

supplied in order to "learn" radio detectors to the expander.

Expander Addressing

If you fit 9955 or 9954 expanders then you must allocate each expander to a

specific range of zone numbers. Select the zone numbers by fitting a jumper

link to one pair of the set of pins marked "Address", as shown in Figure 16.

Zones 9 to 16

Zones 17 to 24

Zones 25 to 32

Zones 33 to 40.

Figure 16. Link Positions to set Expander Addresses

Notes:

1. Fit a jumper in either position 2, 3 or 4 if the control panel is providing zones

1 to 16.

2. Do not allocate two expanders to the same zone number range.

Using Programmable Outputs

OP1 and 2 are voltage free relay contacts. Use programming command 81

for OP1 and command 82 for OP2.

OP3 and OP4 are "pull down type" outputs that provides negative applied

control signals. Use command 83 for OP3 and 84 for OP4 (see "4. Program-

ming"). The system adjusts the output polarity when you select the output

type. Figure 17 shows some example applications for OP3 and OP4.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 101 102

Nessun commento

Cooper Security 9853 Guida di Installazione Pagina 26