Cooper Security 9853 Guida di Installazione Pagina 13
- Pagina / 102
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
496791 7
2. Technical Description
2. Technical Description
Specification
Environmental Grade 2
Operating temperature -10° to +55°C
Humidity 96% RH
Dimensions 310mm W, 385mm H, 95mm D
Weight 4.4 kg (without stand-by battery)
Internal Clock ±10 minutes over one year (depending on the
accuracy of the mains supply frequency).
Radio detector differs 16,777,214 (2
24
-2)
Conforms to BS4737 Part 1 for remote signalled systems, ACPO-IAS Policy,
NACOSS NACP14, ABI log requirements.
Power Supply
All currents accurate to ±5%.
Mains power supply 230VAC, 200mA max, +10%/-15%, 50Hz ±5%
System power supply 13.8VDC, 1.3A total
Conforms to EN50131-6 Type A power supply for Grade 1 and 2 systems.
With the system quiescent, this supply is used as follows:
Control unit power 130mA nominal quiescent, 220mA active
9930 Remote Keypad 20mA quiescent, 35mA with keypad backlight on
9955 Expander 55mA
9954 Expander 20mA typical 30mA max.
The remaining current is available for recharging the battery, driving the
internal loudspeaker, supplying devices through the 9954 expander, and
supplying attached devices through the 12V Aux terminals on the main
connector.
Standby Battery 12 Volt, 7AH or 17AH rechargeable lead-acid, Gel
Type battery (not supplied). (For 17AH battery kit
order part number 8136EUR-02.) Recommended
manufacturers: Yuassa, Yucel or Fiamm. Low
Battery voltage cutoff = 10V. Max recharge time for
17AH battery = 50 hrs
Outputs
O/Ps1 and 2 are relay outputs and O/Ps 3 and 4 are open collector transistor
outputs.
O/P 1& 2 Voltage free, single pole relay contacts rated 24VDC @
3A. Max current for external sounder 500mA.
O/P 3 & 4 500mA, 12VDC. negative applied
ST Siren Test 14.4VDC (For use in France only)
- INSTALLATION AND 1
- PROGRAMMING GUIDE 1
- Contents 3
- 496791 iii 5
- 1. INTRODUCTION 7
- 2 496791 8
- 496791 3 9
- System Features 10
- Detectors 10
- 9955 Radio Expander 10
- Partioned or Single System 11
- User Control 11
- Configurations 11
- 6 496791 12
- 2. Technical Description 13
- Compatible Equipment 14
- Control Unit PCB 15
- 9954 Expander 16
- 3. INSTALLATION 17
- Cabling Keypads and Expanders 18
- Fitting the System 19
- Fitting the Control unit Case 19
- Fitting a 9930 Keypad 19
- Wiring the Control Unit 20
- Cable Entries 20
- Mains Connection 20
- Remote Keypads 21
- 16 496791 22
- Detector Circuit Connections 23
- 18 496791 24
- Connecting Expanders 25
- Expander Addressing 26
- Using Programmable Outputs 26
- Wiring Keyswitches 27
- Using a Communicator 28
- Statutory Information 29
- Application 29
- Compatible PABXs 29
- Approval 29
- Safety Notice 30
- Connecting the Telephone Line 31
- 26 496791 32
- 496791 27 33
- Fitting a Battery 34
- Initial Start Up 35
- 30 496791 36
- 4. Programming 37
- 32 496791 38
- 496791 33 39
- 34 496791 40
- 496791 35 41
- 36 496791 42
- 496791 37 43
- 38 496791 44
- Communications Programming 45
- 40 496791 46
- 496791 41 47
- 42 496791 48
- Leaving Programming Mode 49
- Engineer Reset 49
- Re-entering Programming Mode 49
- Programming Reference 50
- Country Defaults (Command 0) 50
- 496791 45 51
- 46 496791 52
- 496791 47 53
- 48 496791 54
- 496791 49 55
- RedCare Reset (Command 23) 56
- Status Display (Command 28) 57
- 52 496791 58
- System Reset (Command 33) 59
- PA Reset (Command 34) 59
- Alarm Abort (Command 36) 59
- 54 496791 60
- Bell Delay (Command 41) 61
- 56 496791 62
- CSID Code (Command 50) 63
- Abort Reset (Command 53) 64
- BVVO Supervision (Command 54) 64
- Sounder Tamper (Command 59) 65
- 60 496791 66
- 496791 61 67
- 62 496791 68
- 496791 63 69
- 64 496791 70
- 496791 65 71
- 66 496791 72
- 496791 67 73
- Call Mode (Command 101) 74
- Reporting Type (Command 103) 75
- 70 496791 76
- Dynamic Test (Command 108) 77
- Rings to Answer (Command 112) 78
- Access Mode (Command 114) 78
- Account Number (Command 117) 79
- 74 496791 80
- 496791 75 81
- 76 496791 82
- Report Mode (Command 131) 83
- 78 496791 84
- 496791 79 85
- 80 496791 86
- 496791 81 87
- Partition Programming 88
- Introduction 88
- Command Changes 89
- 84 496791 90
- ACPO DD243: 2002 Compliance 91
- Alarm Filtering 92
- 5. Testing 93
- Keypad and Event Log Displays 94
- 496791 89 95
- Printing the Log 96
- 496791 91 97
- 92 496791 98
- 496791 93 99
- 94 496791 100
- 496791 95 101
- DECLARATION OF CONFORMA NCE 102
Prodotti e manuali riguardandi Sistemi di controllo di accesso Cooper Security 9853
(44 pagine)© 2020, manymanuals.it. Tutti i diritti riservati | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale