Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 63)

496478 57

5. Testing

Reading the Log (Command 90)

The control unit keeps a 250 event log of recent events. Each event is

represented by a two digit code, shown on the next page. To review the

event log, make sure the system is in programming mode, then:

1. Key in 90y.

The display shows the most recent event in the log. For a list of the log

codes see the next page.

2. Key in 1 to show earlier events or 3 to see more recent events.

3. Press y to toggle between the event message and the event time.

4. Press X to leave the log.

The table below and on the next page shows all the messages that can

appear in the event log.

Note that neither the Installer nor the user can erase the log.

In the log user codes are represented by numbers as follows:

U00 Installer U06 User code 6 U13 Keyswitch

U01 User code 1 U07 User code 7 U14 Remote Rst

U02 User code 2 U08 User code 8 U15 Download

U03 User code 3 U09 Duress code

U04 User code 4 U11 For future use

U05 User code 5 U12 Telecommand

Keypad and Event Log Displays

Keypad

EEProm Fail,

Codes Defaulted

System Startup

System Tamper

System Tamp Rst

Sounder Tamper

Sounder Tamp Rst

Unn On-Site

Unn Off-Site

Unn Change Unn

Unn Delete Unn

Unn L# Set

Unn L# UnSet

U13 L# Set

U13 L# UnSet

System Rearmed

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 63