Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 43)

4. Programming

496478 37

Restoring All Factory Default Programming

If you wish to restore all factory default options then:

1. Enter programming mode (if you are not already there).

2. Key in 98 Y at the keypad.

The display shows: 98:Load Default

3. Press 1. (You can press X to stop the procedure if you change your

mind at this stage.)

4. Press Y.

The keypad gives a double confirmation tone and the system loads the

factory default command values, erasing all previously programmed

values.

Notes:The log is protected and cannot be erased by the Installer.

Programming Reference

Zone Programming (Commands 01 to 16)

The zone programming commands 01 to 16 take two or more numbers. The

first number describes the zone type, subsequent numbers describe the zone

attributes.

When you key in the zone number and press Y the display shows the zone

number and any text caption for the zone. (Note that the zone text can be

changed using <Downloader>, but not from the keypad.) Press Y again to

start entering the zone types and attributes. When you have entered the zone

type and attributes press Y once more to store the changes.

Zone Types

The following types are available:

Not Used (NU) The system ignores Zones with this type. Key in 0 for

zone that will not be used.

Note: If a zone is programmed as ‘Not Used’, it is not necessary to link the circuit or

anti-tamper connections.

Panic Alarm (PA) (Key in 1) Operating a device programmed as ‘Panic

Alarm’ will start either a silent alarm transmission to the

central station, or an audible alarm, depending on how

you have programmed PA Response, (see command 30).

PA alarms operate whether the system is set or unset,

and cannot be omitted.

Fire (FR) (Key in 2) Smoke or heat detectors connected to FR type

zones cause the speakers to give a distinctive fire signal

(internal sounders pulsing “Dee Dah Dee Dah...”). Fire

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 43