Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 54)

4. Programming

48 496478

Load Full Defaults (Command 98)

Use this command to load default values for all commands.

1. Enter programming mode (if you are not already there).

2. Key in 98 Y at the keypad.

The display shows: Load Defaults

3. Press 1. (You can press X to stop the procedure if you change your

mind at this stage.)

4. Press Y.

The system loads the factory default command values, erasing all

previously programmed values.

Notes:The log is protected and cannot be erased by the Installer.

Leave Programming Mode (Command 99)

To leave programming mode:

1. Key in 99 Y at the keypad.

The display shows: Exit Eng?

2. Press Y.

The display shows: Checking System

and after a few seconds the contol unit

resets itself and returns to user mode.

If any 24 hour, Fire, PA or Technical zones are active when you try to leave

programming mode then the keypad gives an error tone and displays all the faults.

Clear the faults shown on the display and press Y. Repeat steps 1 and 2 and

the control unit should leave programming mode.

Call Mode (Command 101)

You may select one of the following call modes:

Disabled (0) The control unit does not use any communications.

Single (1) Reports to a single telephone number (see Command

115) with a single account number (see Command 117).

Operation: The system dials the number and attempts to

connect with the remote receiver. If it fails, it closes down

and then re-attempts to connect up to a maximum of 15

times.

Alternate (2) Reports to one of two programmed telephone numbers

(see Commands 115 and 116).

Operation: The system dials the first telephone number and

attempts to connect to the remote receiver. If it fails, it will

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 54