Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 27)

496478 21

3. Installation

If either of these functions detect a failure the system gives a programmable

Line Fault Response (programming command 106).

Statutory Information

Application

The built in communicator is suitable for connection to the following type of

networks:

(a) Direct exchange lines (PSTN) supporting DTMF (tone) dialling.

(b) PABX exchanges (with or without secondary proceed indication).

Note: The built in communicator is not suitable for connection as an extension to a

pay-phone or to 1 + 1 carrier systems.

Compatible PABXs

The built in communicator is only approved for use with compatible PABXs.

Correct operation in all circumstances is not guaranteed.

Approval

This product is manufactured to meet all European Economic Area telecom-

munication networks requirements.

The equipment has been approved in accordance with Council Decision 98/

482/EC for pan-European single terminal connection to the public switched

telephone network (PSTN). However due to differences between the indi-

vidual PSTNs provided in different countries, the approval does not, of itself,

give an unconditional assurance of successful operation on every PSTN

network termination point.

In the event of problems you should contact you equipment supplier in the

first instance.

The built in communicator has been approved for the following usage:

(a) Automatic call initialisation.

(b) Operation in absence of proceed indication.

(d) Modem.

(e) Serial Connection.

(f) Multiple Repeat Attempts.

(g) Line Status Monitoring.

Usage other than approved usage or failure to comply with the installation

and programming instructions may invalidate any approval given to the

apparatus, if, as a result, the apparatus ceases to comply with the standards

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 27