Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 50)

4. Programming

44 496478

strates the volume of the tone when you enter the digit.

CSID Code (Command 50)

To allow the customer to use the ‘Remote Reset’ facility, you must program

the control unit as ‘Engineer Reset’ (Command 33 option 1) and then install a

four digit Central Station Identification (CSID) code.

First make contact with the central station and obtain the CSID code, then

ensure that the system is in programming mode. Key in:

50 Y nnnn Y

Where nnnn is the "CSID Code".

The control unit now contains the same CSID code as the central station.

After an alarm the control unit can generate a ‘Control Code’ which will be

recognised by the central station 7300 Remote Reset decode programmer.

After an alarm the user keys in their access code to silence the alarm, but

cannot reset the system. The system generates a four digit code number and

displays it on the keypad. The user calls the central station and tells them the

number shown on the keypad display. The central station verifies the user's

identity, then enters the code number into a special programmer. The pro-

grammer generates a ‘Reset Code’, which the central station gives back to

the user. The user then enters the ‘Reset Code’ at the keypad to reset the

system.

Note: To delete a CSID code key in “0000” over the existing code.

Setting Time and Date (Command 51)

The system has an internal clock/calendar which uses to date stamp the log

print-out. To set the system’s clock/calendar to the correct time and date:

1. Enter programming mode (if you are not already there).

2. Key in 51Y at the keypad.

The display shows the current date, for example: D04 M11 Y99

3. Key in two digits for the day number and press Y. Use leading zeros for

the first nine days of the month.

4. Key in the two digits for the month number and press Y . Use a leading

zero for January to September.

5. Key in the two digits of the year and press Y.

The display shows the current time, for example: H12 M26

6. Key in two digits for the hours of the day and press Y. Use the 24-hour

clock.

7. Key in two digits for the minutes and press Y.

The keypad sounder gives a double “bleep” and the display shows

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 50