Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 62)

4. Programming

56 496478

The system also provides a “custom” mode which allows any combination of

event information. However, you must use <Downloader> to create the

combination required.

SIA alarm transmissions will take considerably more telephone time than

Scancom Fast format since the system transmits extended alarm data to the

central station.

Modem Tone Format (Command 132)

If you select SIA format in command 103 then you can use command 132 to

select the modem tones used by the plug-on communicator. Check with your

central station what type of modem tones are required.

Option 0 Bell 103 tones.

Option 1 300 Baud FSK CCITT V21 modem tones.

Contact ID Options (Command 143)

If you selected Contact ID in command 103 then use command 143 to select

the types of contact ID messages that will be sent.

Option 0 Mode Basic, comprises the messages shown in Fig 28 in the

“Basic” column.

Option 1 Mode Basic + Restore. With this option the system still sends

the messages listed for Option 0, but also sends restore for

Burglar alarm, fire, PA and Tamper.

If the keypad display shows “Custom” when you enter command 143 then

<Downloader> has been used to program this command. Using

<Downloader> you can select any of the Basic messages from Option 0, plus

the following:

Technical alarm Engineer on site Engineer off site

Log downloaded Tamper panel Tamper expander

Keypad tamper Tamper sounder RF jamming

RF supervision fail RF zone low batt. AC fail

Change time Plug-on line fail Battery missing

Battery fault Abort

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 62