Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 44)

4. Programming

38 496478

alarms operate whether the system is set or unset and

cannot be omitted, and will always trigger communica-

tions if fitted.

Normal Alarm (NA) (Key in 3) A zone programmed as ‘Normal Alarm’ will

start an alarm when the system is set.

24 Hr Zone (24) (Key in 4) This zone causes an internal alarm if violated

when the system is unset, and a full alarm if the system is

set. Providing the Installer programs 24hr zones with

‘Omit Allow’, the user can omit 24 hour zones in Day

mode. Note that the control unit re-instates all 24Hr zones

if anyone sets the system.

Final Exit (FE) (Key in 5) Zones of this type must be the last detector to

be activated on exit, or the first to be activated on entry.

You can use zones of this type to finally set the system,

or to start the entry procedure. Use command 39 to set

the exit mode type.

Entry Route (ER) (Key in 6) Use this zone type for detectors sited between

the Final Exit door/detector and a keypad. If an ‘Entry

Route’ zone is violated when the system is set, an alarm

will occur. If the entry/exit timer is running when an Entry

Route zone is violated then no alarm occurs until the

entry/exit timer expires.

Shock

Analyser (SA) (Key in 7) You can apply this zone type to zones 1 to 4.

The system will not accept the attribute for zones 5 to 16.

(See also “Zone Attributes - Sensitivity”.)

Technical (TC) (Key in 8). Use this zone type when you want to monitor

equipment, for example a freezer, without raising a full

alarm.

If a technical alarm zone is activated while the system is

set, the system makes no audible alarm. However, when

a user unsets the system the keypad indicates a fault.

If a technical alarm zone is activated while the system is

unset then the system starts a pulsed tone from the

keypad. If programmed, the control unit also starts com-

munication. When a user enters a valid code the keypad

stops the tone and displays the zone.

Zone Attributes

Specific zone types can have one or more attributes programmed by the digit

after the zone command and type. (To remove an attribute, key in the at-

tribute digit again.)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 70 71

Commenti su questo manuale

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 44

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Cooper Security M-Series