Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 35)

4. Programming

496478 29

4. Programming

Entering Programming Mode

“3. Installation - Initial Power Up” describes how to enter programming mode

for the first time in a new installation. If you wish to enter programming mode

at any other time:

1. Make sure the system is unset.

2. Press 0, then key in the Engineer’s code (default 7890).

The display shows: Installer Mode

You are now in programming mode.

Note: While the system is in programming mode all keypads except the one you are

using will be locked, displaying “Busy”.

Programming Commands

When delivered from the factory the control unit already has default program

settings. To change the default programming you must be in programming

mode. Then:

1. Key in the appropriate command number and press Y.

The display shows the current value of the command.

2. Key in digits to select the value you require.

The display shows the new value.

3. Press Y to store the new value of the command.

If at any time you change your mind, repeat step 1 to 3. The table on the

following pages shows the commands and their options. ( A “Y” next to a

command value shows that it is the factory default.)

The factory default access codes are:

Engineer Code 7890

Access Code User 1 1234

Access Code 2 to 8 X 002 .... X 008 (inactive)

Duress Code X009 (inactive)

Notes:

1. The factory default Access Codes 02 to 08 and the Duress Code must be

changed by USER 1 to a four digit number to activate them. See “9750 User

Guide” for a more detailed explanation of changing user access codes.

2. To change the default zone descriptions use <Downloader>.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 35