Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 56)

4. Programming

50 496478

Entering a valid access code silences the sounders and

the displays indicates a telephone line fault. The system

can be set again with the line fault present.

Note: Audible response is the NACOSS recommendation for line fault.

If the system is set then the control unit logs the event but

the keypads do not give any tone or display. The control

unit cancels any programmed bell delay if the line is out of

order when an alarm occurs.

Silent (2) If the system is unset then the keypad display indicates a

telephone line fault and the control unit logs the event.

The system may be set again with the line fault present.

If the system is set then the keypad does not give any

display or tone but the control unit does log the event. The

system cancels any programmed bell delay if the line is

out of order when an alarm occurs.

Line Integrity Checking (Command 107)

Integrity off (0) The control unit does not perform any line integrity

checks.

Integrity on (1) With this option enabled, the system seizes the telephone

line 12 hours after the last call and dials the first digit of

the first programmed telephone number. If the dial tone

disappears, then the line is good and the system hangs

up and resets the 12 hour timer. If the dial tone does not

disappear (the out of service tone is on the line), then the

system triggers the programmed Line Fail Response.

Dynamic Test (Command 108)

In dynamic testing the system makes a test call 24 hours after the last

communication. Select option 0 to disable dynamic test calls. Select option 1

to enable dynamic test calls.

Three Way Call - UK only (Command 109)

To use Three Way Call you must set the dialling type to DTMF (see com-

mand 102) and make sure that the BT Network Services Option of ‘Three

Way Calling’ is available on the telephone line to which the communicator is

connected.

Three way off (0) Disabled

Three way on (1) Three Way Call.

Operation: If the control unit triggers the communicator

and the communicator detects Off Hook or Incoming

Ringing, the communicator then sends a 80 ms trigger

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 56