Cooper Security M-Series Manuale delle Istruzioni Scaricare il pdf (Pagina 45)

4. Programming

496478 39

Chime (C) (Key in X1) When enabled by the user, the system gives

a non-alarm warning tone when any zones programmed

as ‘Chime’ are opened. This facility operates only while

the system is in Day.

Notes:

1. ‘Chime’ is available only for Normal Alarm, Final Exit, Entry Route and Shock

Analyser zone types.

2. To make chime available from the keypad sounders but not the internal

sounder then program command 22 with option 0.

Soak Test (S) (Key in X2) Use this zone attribute if you want to place

under long term test a detector that you suspect is giving

false alarms. Zones with this attribute are disabled. If the

zone is opened while the system is set then the Service

LED glows and the control unit logs the event as a “Soak

Test Fail Zn” (n is the zone number) without sounding any

bells or starting signalling. The Service LED stays alight

until the Engineer resets the system.

Note: Soak test is available only for Normal Alarm, Entry Route and Shock Analyser

zone types.

Double

Knock (2) (Key in X3) Zones with this attribute will cause an alarm

condition only if the sensor generates two alarms events

within a five minute time window, or if the zone remains

open for more than 10 seconds. Programming a zone as

‘Double Knock’ is a way of reducing false alarms caused

by environmental changes, but is not normally recom-

mended.

Note: ‘Double Knock’ is available only for Normal Alarm and Entry Route zone types.

Omit Allow (O) (Key in X4) When applied to a zone, this attribute allows

the user to omit the zone.

Note: ‘Omit Allow’ is not available for Final Exit, PA and Fire zones.

Part Set B (b) (Key in X5) When applied, the zone will be armed when

the user selects Part Set B. Zones not selected will be

omitted.

Sensitivity (Key in X7) When you use this command you must also

enter an extra digit in the range 1 to 4 in order to set the

sensitivity of the shock sensor. 1 is least sensitive, 4 is

most sensitive. Note that to use this attribute you must

make one of zones 1 to 4 a shock analyser type. To

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 70 71

Nessun commento

Cooper Security M-Series Manuale delle Istruzioni Pagina 45