Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 69)

9651 Programming - Programming Commands

11772232 Page 65

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 73) requires

that Command 185 is set to option 0.

199: Display Zone Circuit Resistance

For information on this command, see page 72.

200: Forbikobler Entry Timer

This command sets the interval between a user entering the premises through

a Forbikobler entrance and an alarm going off, using one of the independent

entry timers configured with Commands 201 to 204. Any of the entry timers

can be assigned to any Forbikobler entrance. Entering the entry code into the

Forbikobler unit starts the selected entry timer.

Option

1 Entry Timer 1 (default)

2 Entry Timer 2

3 Entry Timer 3

4 Entry Timer 4

201 to 204: Entry Timers 1 to 4

Entry timers set the interval between a user entering the premises and an

alarm going off. There are four independent entry timers so that you can set

different intervals for different entrances, reflecting the time required to

complete each entry route.

Note: These replace the level-specific timers available on earlier control units

(formerly set with Commands 43, 64, 74 and 78). They provide a more

flexible approach to timed entry routes, enabling any timer to be selected

for any entrance.

Each entry timer can be assigned to any zone of types FE (Final Exit), ER

(Entry Route) and FB (Forbikobler), using the zone programming commands

01 to 08 (see page 35). Set zone attribute X7 to a value between one and four

to select the required entry timer. Opening the zone starts the selected entry

timer.

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 73) requires

that the Entry Timer does not exceed 45 seconds.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 69