Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 47)

9651 Programming - Programming Commands

11772232 Page 43

31: Zone Tamper User/Engineer Reset

Use this command to ensure that the system complies with national

requirements for resetting zone tamper indications while the system is unset.

If you select option 0 (the default), the user can reset the system after a zone

tamper.

If you select option 1, the user can silence the alarm after a zone tamper but

an engineer must reset the system by entering the Engineer Code, or by

using a remote or anti-code reset (Commands 23 and 50).

Note: See Commands 37 and 38 for reporting and resetting system tampers

(for example, attempts to open control unit or keypad cases).

33: System User/Engineer Reset

To require an engineer reset, select option 1. To permit a user reset, select

option 0 (the default). Certain types of events always need an engineer reset,

irrespective of the option that you choose here:

° Auxiliary 12V supply fuse blown

° Keypad missing or failed

° A low battery at the control unit.

34: PA User/Engineer Reset

To require an engineer to reset the system after a PA, select option 1. To

permit a user to reset the system after a PA, select option 0 (the default).

35: First Circuit Lockout

If you select option 0 (Lockout), the first zone to activate during the set cycle

is ignored until the system is unset. This is the default.

If you select option 1 (Rearm), the whole system (including the first zone to

activate) rearms at the end of the programmed bell run time, provided that the

zone is closed. While the zone is open, the system locks it out. If the zone

closes after the system rearms, the system reinstates it.

36: Alarm Abort

Users occasionally trigger false alarms by accident. Select option 1 to permit

them to abort under these circumstances.

If a user accidentally triggers an alarm while the system is set, the control unit

transmits an intruder alarm and starts the Bell Delay and Alarm Abort timers.

To abort the alarm, the user must enter a valid access code during the abort

period. If the user enters a valid code within this time, the system transmits a

restore of the intruder alarm and simultaneously transmits an abort.

Select option 0 (the default) to prevent users from aborting alarms in this way.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 47