Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 49)

9651 Programming - Programming Commands

11772232 Page 45

Notes on Lock Set:

1. Do not connect more than one lock switch (or any other device) to the

keypad ET terminals. Do not attempt to fit two lock switches.

2. To set the system, the user first enters their access code at a keypad or

operates a keyswitch. The control unit starts to emit the exit tone. The

exit time is infinite in this option. The user then operates the Final Exit

zone and turns the key in the lock switch to "locked". The system sets 7–

12 seconds after the lock switch contacts open; the delay is set with

Command 182 (see page 64).

3. To unset the system, the user turns the lock switch to "unlocked" (which

closes the contacts). The keypads start to emit a continuous tone; this is

not affected by PD6662 / pr EN 50131-1: 2004, as the possession of a

key indicates an authorised user. At this point, the user can lock the lock

switch again without causing an alarm. When the user opens the Final

Exit zone, the control unit starts the entry timer. The user completes

entry by unsetting the system in the normal way.

4. If an intruder opens the Final Exit door without first unlocking the lock

switch, the control unit immediately starts an alarm.

40: System Auto Rearm

This command sets the number of times that the system will rearm all closed

zones when the bell duration expires. If you select option 0, the system will

not rearm (it will go into alarm only once). Select option 1 to rearm once, 2 to

rearm twice, 3 to rearm three times or 4 to rearm every time the bell duration

expires.

Use this command in conjunction with Command 35, First Circuit Lockout.

If the system has rearmed, the control unit gives an audible internal alarm

instead of the normal entry tone when a user enters the premises through the

Entry Route.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 49