Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 59)

9651 Programming - Programming Commands

11772232 Page 55

03 Set Latch: active when the system is set and inactive when the

system is unset or an alarm condition occurs. It is active for one

second when a reset is performed or the control unit leaves installer

mode. It is also active during Walk Tests.

04 Shock Reset: used to reset shock sensors (for example, the "Viper").

The output is triggered by the control unit at the start of the Exit Time

and remains active for five seconds.

05 Walk Test: active during both engineer and user Walk Tests and

during the time between silencing and resetting the system. It is used

on movement detectors that are able to switch off the Walk Test lamp

in any state other than a Walk Test.

06 Ready Lamp: active when the system is unset and if there are no

faults. It is inactive when the system is full or part set, during any

alarm or if a circuit fault prevents setting. It is also active when the

control unit is in installer mode.

07 24-hour Alarm: activated when a zone designated as 24-hour is

violated and deactivated when the system is disarmed.

08 Strobe: activated during an alarm and deactivated when the system is

disarmed.

09 Smoke Reset: designed to be connected to low-voltage smoke

detector reset terminals. It is active for 3 seconds when the system is

reset after an alarm.

10 Siren Test: activated when the user performs a sounder test.

11 Strobe Set A: active for 10 seconds after the system is set. It can be

used to operate the Strobe output to give a visual indication that the

system has completed setting.

12 Pulse Set 1: active for the time set by Command 170 when someone

sets the system (same as type 26).

13 Pulse Unset 1: active for the time set by Command 172 when

someone unsets the system and during a Fire alarm or PA (same as

type 30).

14 Not used.

15 Set Complete: active for 10 seconds after someone sets the system.

16 Unset Complete: active for 10 seconds after someone unsets the

system or disarms it after an alarm.

26 Pulse Set 1: active for time set by Command 170.

27 Pulse Set 2: active for time set by Command 170.

28 Pulse Set 3: active for time set by Command 170.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 59