Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 60)

Programming - Programming Commands 9651

Page 56 11772232

29 Pulse Set 4: active for time set by Command 170.

30 Pulse Unset 1: active for time set by Command 172.

31 Pulse Unset 2: active for time set by Command 172.

32 Pulse Unset 3: active for time set by Command 172.

33 Pulse Unset 4: active for time set by Command 172.

34 Fire: active during a Fire alarm.

35 PA: active during a PA.

36 Set Fail: active for 60 seconds from when a set command fails.

37 General Fault: active for all faults except AC Fail, Anti-Mask, Battery

Fault, Line Fault, Zone AC Fail, Zone Battery Fault and Zone Low

Battery.

38 All Fault: active for all faults (including AC Fail, Anti-Mask, Aux DC,

Battery Load Test Fail, Battery Missing, Comms Fail, Keypad Ident

Fail, Line Fail, Low Battery, Plugby Fail, uCom Fail, Zone AC Fail,

Zone Battery Fault, Zone Fault, Zone Low Battery and Zone Pwr O/P).

85: Burglar Communication Rearm

This command determines what happens to the "burg" communications output

(or channel) at the end of the bell run time.

Option

0 Latched (default). The output stays active until an engineer or user

resets the system.

1 Rearm. The system turns off the "burg" channel when the bell run time

has expired. Once the channel is inactive, the system is ready to

report any new alarm.

Notes:

1. Ensure that Command 40 System Auto Rearm is set to 1, 2, 3 or 4 in

order to enable Command 85.

2. If Alarm Abort is enabled (Command 36, option 1), the "burg" channel

restores if the user unsets the system.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 60