Cooper Security 9651 Manuale di Installazione Scaricare il pdf (Pagina 45)

9651 Programming - Programming Commands

11772232 Page 41

23: Remote Reset Enable

Option 1 enables Remote Reset, which is designed to operate with the plug-

by communicator. After an alarm, the user keys in an access code to silence

the alarm but cannot reset the system. The first alarm message to display and

the Service lamp remain visible. The user contacts the Alarm Receiving

Centre (ARC), which verifies the user's identity and then sends a signal to the

control unit. The Service lamp goes out and the user can then reset the

system with any valid access code, provided that there are no faults.

Use option 0 (the default) to disable this function.

Notes:

1. To ensure option 1 works correctly, you must set System Reset to

Engineer (Command 33 option 1) and set a CSID code (Command 50).

2. To comply with PD 6662 / prEN 50131-1: 2004, the system must be set

to hide status information after 30 seconds (Command 28), in which case

the Service lamp will go out after the same period.

25: Internal Sounder Delay and Duration

Option 0 (the default) makes the internal sounder use the external Bell Delay

and Duration times. Option 1 makes the internal sounder continue after the

external Bell Delay expires, stopping only when a user enters an access code.

27: Exit Fault External Sounder

This command controls what happens when an exit timer completes and a

zone is still violated (for example, when a door is not shut).

Option

0 Internal (default). System operates the internal sounders only.

1 Local. System operates both internal and external sounders.

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 73) prohibits

an alarm after a failure to set the system, which would require

Command 27 to be set to option 0. However, if external sounders are

preferred, 9x5x control units also provide "Set Fail" outputs that can be

used to indicate that an alarm resulted from a set failure.

28: Status Display

If you select option 0 (the default), the keypad displays "Level Set"

continuously for the whole time that the alarm system is set. The keypad

lamps are illuminated if a relevant condition exists. Select option 1 to clear the

display and turn off the lamps 30 seconds after the user's last action.

The following table shows the effect of these settings in more detail.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Nessun commento

Cooper Security 9651 Manuale di Installazione Pagina 45