Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 97)

i-on40 Testing

Page 93

12. Press X to leave the sub menu.

To see IP Network information for the built-in Ethernet

port:

1. Select About – Comms from the Installer Menu.

The bottom line of the display shows the

communications module type (or “None” if no module

is fitted).

2. Press n.

The bottom line of the display shows “Panel

Ethernet”.

3. Press >.

The bottom line of the display shows “IP Link Status”.

4. Press >.

The bottom line of the display shows “OK” if the

control unit has successfully connected to a PC by

way of an Ethernet cable.

5. Press < then n.

The bottom line of the display shows “IP Address”.

6. Press >.

The bottom line of the display shows the IP address

currently assigned to the built-in Ethernet port. Note

that this may have been assigned by DHCP.

7. Press < then n.

The bottom line of the display shows “Subnet Mask”.

8. Press >.

The bottom line of the display shows the current

subnet mask. Note that this may have been assigned

by DHCP.

9. Press < then n.

The bottom line of the display shows “Gateway

Address”.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 97