Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 42)

Installer Mode Programming i-on40

Page 38

Type: Active when: Assign to

Partitions?

External PSU

Fault (15)

An external power supply

fault signal triggers a

Power output fault zone.

The control unit deactivates

the output when the zone

has been restored and a

user has acknowledges the

fault by entering a valid

access code.

Tamper (16) The control unit detects

tamper on any device;

deactivates when tamper is

reset.

Yes

Zone Omit

(Setting) (17)

The user Omits a zone

while setting the system.

The output deactivates

when the control unit

restores the zone.

Yes

Zone Omit

(System) (18)

(Operates only when

DD243 is enabled.) In the

event of an unconfirmed

alarm, the system will

rearm itself when the

confirmation timer expires.

If the zone that caused the

unconfirmed alarm is still

active at the time of the

rearm, the control unit will

omit that zone and activate

the output. The control unit

will restore the zone and

output when a user or

engineer resets the

system.

Yes

General Fault

(19)

There is any event that

causes an alert indication

on the keypad.

Yes

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 115 116

Commenti su questo manuale

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 42

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Cooper Security i-on40