Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 106)

Appendix III i-on40

Page 102

Installation and Programming

If the installer wishes to employ wired zones only they

should use FSL wiring. The i-on40 provides connections

for 16 FSL zones on its pcb.

For best operation, there should be two keypads: one

fitted in the Loading Bay and the other fitted in

Reception.

When starting the control unit for the first time, select

Partitioned system (not part setting system).

To make the system easier to use it is advisable to enable

the ABCD LED’s on the keypads. However the installer

must make sure that this does not break the EN50131

requirement that no indication of the status of the system

should be visible if the keypad is in a public area.

In the i-on40 Partition 1 is always the common area. Use

Partition 1 for the Foyer, Kitchen and Toilet. Partition 2

can be used for the Factory and Loading Bay. Partition 3

can be used for the Office and Reception. To make the

common area (P1) follow the status of other partitions

use the Partitions - Full Set Link option (see below).

To avoid false alarms make the alarm response of the

common area (Partition 1) Siren + Comms and the other

two Partitions Siren only.

Zone Programming

Location Zone Name Zone Type Partitions

Front Door 01 Front Door Final Exit P1

Foyer PIR 02 Foyer PIR Entry Route P1

Loading Bay

Entrance

03 LB to Foyer Final Exit P2

Roller shutter 04 Rshutter Normal Alarm P2

Loading Bay PIR 05 LBay PIR Entry Route P2

Factory PIR 06 Factory PIR Normal Alarm P2

Factory Fire Door 07 Factory FD 24 Hour P2

Kitchen PIR 08 Kitchen PIR Normal Alarm P1

Office Fire Door 09 Office FD 24 Hour P3

Office PIR 10 Office PIR Normal Alarm P3

Reception PIR 11 Recpt PIR Entry Route P3

Reception Entrance 12 Rcept Door Final Exit P3

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 106