Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 38)

Installer Mode Programming i-on40

Page 34

type, and change its polarity. Programming plug-by

outputs is the same as programming wired outputs, but

you must use the Outputs – Plug-by Outputs menu.

Note: The activity of the plug-by outputs is affected by

the alarm response you select. For example, if you

select the alarm response “Siren” for Part Set B, then

the control units will not trigger the Plug-by-Outputs

if there is an alarm when the system is in part set B.

To make the plug-by outputs operate you must

select an alarm response that has communications.

Output Types

(Hint: You can select an output type quickly by keying

the number shown in brackets after the type’s name, for

example:“04” to select Open/Close, “02” to select Panic

Alarm, “19” to select General Fault. The number does not

appear on the keypad display.)

The output types available are:

Type: Active when: Assign to

Partitions?

Not Used (00) (Never)

Fire Alarm

(01)

The control unit starts a

fire alarm.

Yes

Panic Alarm

(02)

The control unit starts a

panic alarm.

Yes

Any of the following zones

are triggered:

Normal Alarm

Tamper (in a set system)

Entry Route

Tamper Zone (in a set

system)

Entry time expires

Burglar Alarm

(03)

24 hour (in a set system)

Yes

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 115 116

Commenti su questo manuale

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 38

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Cooper Security i-on40