Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 31)

i-on40 Installer Mode Programming

Page 27

When you select Disabled, the control unit stops

using the Ready to Set LED the Info Module.

3. Press Y to confirm the change.

WAMs

The i-on40 can operate up to two 770r WAM modules.

Although the WAM provides five different modes, when

working with an i-on40 only three of them are relevant.

The installer selects the mode when commissioning the

WAM hardware. The modes provide the following

functions for the i-on40 control unit:

Mode 1 Repeater Module. The WAM repeats the signals

from any detectors within its range, amplifying them to a

level that the i-on40 control unit can detect. This allows

you to increase the area covered by detectors.

Mode 2 Output Module. The WAM accepts commands

from the i-on40 control unit to operate wired outputs.

(The WAM can also accept commands from other i-on or

Homelink transmitters.) Each WAM output corresponds to

one of the radio outputs on the i-on40 as follows:

OUTPUTS

WAM

NO:

WAM OP

No.

Panel OP

No.

1 1

2 2

3 3

4 4

1 5

2 6

3 7

4 8

Table 1. WAM OPs to i-on40 radio OPs

Mode 4 Sounder Module. The WAM operates as a radio

link to allow you to remotely connect a standard wired

siren to the i-on40 control unit. In this mode the WAM

also provides inputs so that the wired siren can report

back tampers, low battery or other trouble conditions.

Adding a WAM

To ensure correct operation you must first select the

desired mode on the WAM (see the WAM Installation

Guide) and then teach the WAM’s identity to the i-on40

control unit.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

Commenti su questo manuale

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 31

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Cooper Security i-on40