Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 35)

i-on40 Installer Mode Programming

Page 31

3. Press > to give the output a name.

See page 7 for hints on editing names.

Press Y when you have finished editing the name.

To give a radio output a type:

1. Select Outputs – Radio Outputs – Edit Outputs.

The bottom line of the display shows the first of eight

available radio outputs.

2. Press u or n to select the radio output that you wish

to give a type and press Y.

The bottom line of the display shows the word

“Name”.

3. Press n and then Y to see the list of types.

You can select any of the types listed on page 34

onwards.

Press Y to store any changes to the type.

Note: Partitioned Systems

If you are programming a partitioned system then at

this point, for some output types, the top line of the

display shows “Partition?”. The bottom line of the

display shows “Partition 1 Yes”. This means that the

system is asking if you want to allocate the output to

Partition 1.

You can remove the output from Partition 1 by

pressing

to change the “Yes” to a “No”.

Press

to scroll to other Partitions. Press

to assign the output to each Partition as required.

Press

when you have finished assigning outputs to

Partitions.

4. Press n to scroll down to the next output.

Wired Outputs

To use the control unit’s wired outputs you must program

their behaviour by giving them an output type. You can

also give each wired output a name.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 35