Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 50)

Installer Mode Programming i-on40

Page 46

menu but does not give any exit tones.

When the system sets the keypad gives

a double beep confirmation tone.

The keypad(s) give a double beep

confirmation tone at the end of all

setting modes.

Settle Time

This option allows you to define a time delay to allow

detectors to settle before the system sets. This may

be needed if detectors are being set off by air

movements caused by the final door being closed.

During this period, the sounders stop and the system

sets but the control unit ignores any alarms

generated by the detectors.

Enter two digits to specify a time in seconds, from 01

to 30.

Note: This option is available for Final Door Set exit mode

only.

Exit Time

The exit time can take any value between 10s and

120s.

Note: If you select Final Door Set or Instant Set for the

exit mode then the Exit Time option does not appear

in the menu.

Entry Time

The entry time can take any value between 10s and

120s. The entry time you select in this option applies

to Full set and all Part Sets.

Strobe on Set (Part Set Strobe Set)

When set to ON this option causes the control unit to

activate any output programmed as Strobe, plus the

strobe on any 760ES wireless siren. The

outputs/strobes are active for three seconds after the

system sets. Strobe On Set applies to Full Set and all

the Part Sets.

Strobe on Unset (Part Set Strobe on Set)

When set to ON this option causes the control unit to

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 50