Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 54)

Installer Mode Programming i-on40

Page 50

Quick Omit

This option allows users to omit a zone that is active (has

it’s alarm contacts open) while they are setting the

system. The zone must have the Omittable attribute (see

page 16).

Yes By pressing Y the user can set the system if there

are zones with the Omit Allowed attribute active.

No The user must go to the Omit Menu to set the

system if a zone is active.

User Code Required

Use this option to ensure that an installer or maintainer

cannot gain access to program the system unless a user

is present:

Yes After the installer/maintainer enters their access

code, the system asks for a user access code

before allowing access to the Installer Menu.

No The installer/maintainer can enter the Installer

Menu by simply keying in their own code.

User Reset

This menu option determines under what circumstances a

user or the installer can reset the system after an alarm.

Zone alarms

(Appears when if System Options – DD243 – Confirmation is

set to “Off”, see page 51.)

Yes The user can reset the system after an alarm

triggered by a zone’s alarm circuit.

No The installer must reset the system after an alarm

triggered by a zone’s alarm circuit.

Zone Tampers

Yes The user can reset the system after an alarm

caused by a zone’s tamper circuits being

triggered.

No The installer must reset the system after an alarm

caused by a zone’s tamper circuits being triggered.

Note: This setting is required for INCERT approval.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 54