Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 15)

i-on40 Installer Mode Programming

Page 11

2. When you have found the zone you wish to edit press

> or Y.

The bottom line of the display shows “Name”.

3. Press u or n to see the Type, Attributes or Partition

options for that zone. Press

> or Y to select the

option you wish to change.

Note: If you selected “Part set mode” during Initial

Power-up then the display will not show the

Partitions option (see System Options–Restore Defaults–

Factory Defaults on page 53 if you want to change the

system from Part Setting to Partitions).

If a zone has the type “Not Used” then the Attributes

and Partition options do not appear.

4. Press Y to confirm and store any changes.

Changing Zone Names

For hints on editing zone names see page 7.

Zone Types

When the control unit first learns a detector the zone type

defaults to Normal Alarm. The bottom line of the display

shows a “*” at the beginning to show the zone’s current

type.

(Hint: You can select a zone type quickly by keying the

number shown in brackets after the type’s name, for

example:“05” to select Final Exit, “02” to select Fire

Alarm, “11” to select External PSU A/C Fail. The number

does not appear on the keypad display.)

The zone types available are:

Not Used (00)

The alarm system will not respond when an event

triggers this detector.

Panic Alarm (01).

Operating a device programmed as ‘Panic Alarm’ (PA)

will start an audible alarm. If a communications

module is fitted there may also be an alarm

transmission to the Alarm Receiving Centre (ARC),

depending on how you have programmed the ARC

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 15