Cooper Security i-on40 Guida di Installazione Scaricare il pdf (Pagina 71)

i-on40 Installer Mode Programming

Page 67

Burg Comms Rearm

(This menu appears only if you select “Fast Format” in

Communications - Report Type.) This menu option

determines what the control unit does with the “Burg”

Fast Format channel 3 at the end of the siren run time.

There are two options:

Disabled

The channel stays active until an Installer or user

resets the system.

Enabled

The system rearms Channel 3 once the siren timer

has expired. Once the Channel is rearmed, the

system is ready to report any new alarm. The system

bypasses any detectors that are still triggered.

Notes:

If a Final Exit Zone is triggered, Channel 3 becomes

active at the end of the Programmed Entry time.

21CN FF Ack Time

(This menu appears only if you select “Fast Format” in

Communications - Report Type.)

A PSTN line connected to a BT21CN line (or equivalent)

will take longer to acknowledge a Fast Format

transmission. This option allows you to adjust the length

of time that the control unit waits for the ARC

acknowledgement. You can adjust the acknowledgement

time from a minimum of 400ms up to a maximum of

1200ms in 100ms steps.

Send Tamper as Burg

When using CID reporting this option allows you to

program the control unit to send tampers as alarm.

If you select Disabled, (the default) then the control unit

sends all CID messages as specified in Communications –

ARC Reporting – CID/SIA Events.

If you select Enabled then for full alarm response the

control unit sends tampers as burglary (BA) and sends

Contact ID 130 in place of Contact ID 137.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 115 116

Nessun commento

Cooper Security i-on40 Guida di Installazione Pagina 71