Cooper Security 9651 Guida Utente Scaricare il pdf (Pagina 21)

4. Special Functions

Page 17

Key 9: Testing Detectors

You can set the system so that it will allow you to walk around and test each

of the detectors (a walk test). Do this when the premises are empty to avoid

other people triggering movement detectors before you do, which would

confuse the results of the test. If a detector fails the test, contact your alarm

company and ask them to check the system.

Notes:

1. You can abandon the test at any time by pressing .

2. You cannot test Fire, 24-hour, or Hold Up Alarm zones, or tamper circuits with

this command. If you wish to test them, contact your alarm company.

To test detectors:

Key in an access code (or present a tag).

Press 9.

This display shows:

Walk Test

Walk around your premises and trigger the

detectors in turn. DO NOT try to test Fire, 24-hour,

or Hold Up Alarm zones, or tamper circuits.

When you trigger a detector, the keypad and

internal sounder give a short tone.

The display shows 'A' for alarm, followed by the

zone number of the detector.

If you trigger more than one detector, the display

shows the zone numbers in turn.

A: Zone 02

Press  to stop the test when you have triggered

all the detectors.

Master User Functions

Key 4: Setting up Users

Note: Only the master user (U01) can set up users.

The system can store up to 50 different user access codes. Each access code

must contain four digits. For security, you should give one code to each

person who has responsibility for setting and unsetting the system: do not

allow users to share codes.

When the system is delivered from the factory, all access codes are set to

default values. The default for the master user (U01) is "1234". The master

user should change this immediately to a code known to no one else.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Nessun commento

Cooper Security 9651 Guida Utente Pagina 21