Cooper Security Homelink 75 Guida Utente Scaricare il pdf (Pagina 19)

7510r

Page 15

Programming

Entering Installer Menu

1. Make sure the system is unset and showing the

standby screen (time and date).

2. Press Menu.

3. Key in your Installer access code.

(When delivered from the factory the default Installer

access code is “7890”).

When you key in the last digit of the access code the

keypad displays the first item on the Installer Menu.

4. Press u or n to display more items from the menu.

5. Press SELECT to enter that item of the menu.

Leaving the Installer Menu

1. Press DONE or BACK until the top line of the display

shows the words “Installer Menu”.

2. Press EXIT to leave Installer Menu.

The display shows “Leave Installer Mode?”.

3. Press YES.

The display shows the time and date. The system is

ready for use.

Restoring the Access Codes (1

stage Reset)

If the user and/or Installer codes are lost then:

1. First remove mains power, then open the case and

disconnect the battery (see Figure 4).

2. Identify the Reset pins on the main PCB (see Figure

4).

3. Short the Reset pins together using a small wire link.

4. Reconnect the battery.

Note: If you need to run the control unit from the battery

temporarily, then briefly short the Kickstart pins

together. The control unit will not operate from a

battery unless you do this.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Nessun commento

Cooper Security Homelink 75 Guida Utente Pagina 19